Jett-on eSIM Installation Guide

1 Check if Your Device Supports eSIM

Go to Settings > About Phone > Status > EID. If an EID number appears, your device supports eSIM (e.g., OPPO Find X5 Pro, Reno 6 Pro). Also, ensure your device is network-unlocked.

2 Ensure Internet Connection

Make sure your device is connected to Wi-Fi or mobile data. A stable internet connection is required for eSIM activation.

3 Remove Conflicts with Other SIMs

Go to Settings > Mobile Network > SIM Card & Mobile Data and disable or remove other eSIMs or physical SIMs. OPPO devices typically allow only one SIM for calls and data at a time.

4 Install Your eSIM

Using QR Code:

Go to Settings > Mobile Network > SIM Card & Mobile Data > Add eSIM
Scan the QR code provided by Jett On
Tap "Add eSIM" to confirm (Do not close the screen during installation)

Enter Details Manually:

Go to Settings > Mobile Network > SIM Card & Mobile Data > Add eSIM > Manual Entry
Enter the SM-DP+ Address and Activation Code (Provided in your email or below your QR code)
Tap "Add eSIM" and wait for the installation to complete (May take up to 10 minutes)

5 Set Jett On as Default Data Line

Go to Settings > Mobile Network > SIM Card & Mobile Data, select the newly added eSIM, rename it to "Jett On", and set it as the default data line.

Disable the physical SIM to prevent it from consuming data.

6 Enable Data Roaming

Go to Settings > Mobile Network > SIM Card & Mobile Data > Jett On and enable "Data Roaming". This is required for the eSIM to work.

7 Refresh Network Connection

Turn on Airplane Mode for 10 seconds, then turn it off. This refreshes the network signal.

8 Test Your Internet

Open Chrome or another browser to check your connection. If the page loads, your eSIM is working!

Need Help?

Contact our support team if you face any issues:

Oppo eSIM Installation Guide